Duplicating Measurement Points

How to Execute

Right-click on a measurement point in the datalist of Measurements tab in Measurement Panel to open the context menu, then select Duplicate to open Duplicate Setting dialog.

Icon	Item	Action
	Load	Open the Load dialog where you can load a file discribing duplication settings.
	Save	Open the Save dialog where you can save duplication settings into a file.
	Type	Specify the placement and order of the duplicated measurement points.
	nx	Specify the number of arrays in the X direction.
	dx	Specify the pitch of the array in the X direction.
	ny	Specify the number of arrays in the Y direction.
	dy	Specify the pitch of the array in the Y direction.
	Apply Array Info from Jobdeck	Specify whether to get the number of arrays and the pitch from the placement information in the Jobdeck file.
	Duplicate to List End	Specify whether the duplicated measurement point is placed after the original measurement point or after the whole measurement point.
	Select Grid Points to Duplicate	Specify whether to duplicate a measurement point only to selected chips of array in Jobdeck.

The pitch in X and Y direction can be specified on screen with mouse by clicking on icon and then clicking the start and end points on screen.

Press OK to duplicate the measurement point.

If the size of the source and destination figures are different, no measurement point will be created, but you can specify a tolerance in Preference to allow creating measurement points for figures with slightly different sizes. If no similar figures are found for creating measurement point, you can search the surrounding figures to find a figure that can create a measurement point. See Duplicate/Length Tolerance, Duplicate/Search Retry Range in Preference Action/Recipe Creation/Add Measurement page.

Duplicate Measurement Point to Selected Chip of Array

If Select Grid Points to Duplicate is ON, it is able to duplicate measurement point to selected chip of array. Chips to which the measurement point is duplicated can be individually specified with buttons.

When Jobdeck is OFF, the display is in a table format according to the input nx, ny, dx and dy, with the origin at the original measurement point. When Jobdeck is ON, the display is in a table format with the origin at the lower left and spreading to the upper right regardless of the mirror or pitch. If there are multiple arrays referencing the same chip, measurement point is duplicated only to chips of array where the original measurement point is located. Measurement point is duplicated only to coordinates of the chips that are turned ON in this table. The element framed in red are the coordinates of the original measurement point and cannot be turned ON. The entire table can be turned ON/OFF by clicking in the upper left corner.